Panasonic WZ-AD96 - Manual (Page 18)

Q uick S tart
Join the 6 steps below before you start digital recording.
1. Connect an analog source to the input channel on the rear panel.
2. Connect ADAT output or AES/EBU outputs to an external digital device
(for example a digital mixer, ADAT or DAT).
3. Turn on the AD converter, and confirm that POWER LED on the front
panel lights.
To reset to DEFAULT settings, turn on the AD converter while holding
down FREQ and CLOCK buttons at the same time.
4. Supply +4 dBu analog input, and adjust input trimmer so that REF LED
lights (lights in amber for AD96M).
The default setting of REF level is -20 dBFS.
5. Repeat step 4, level adjustment for the rest channels.
6. Play the connected analog source. 'I’hcn confirm that the level meter on
the AD converter swings, at the same time that the connected digital
device outputs analog signals or moves its meter.
See the next chapter, Adjustment and Setting, for REF level adjustment.
C h a p t e r 2 ___________________________________________________
1 9