Mounting in the rack – Panasonic WZ-AD96 User Manual

Page 30

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

C h a p t e r 4

DB25Y

able

To connect the AD converter (TDIF Card installed) with the DA converter

WZ-DA96 and a DTRS device (DA

88 and so forth) you need to build a Y cable

shown below.

MOUNTING IN THE RACK

The AD converter is installed in an EIA 19” rack as follows. .

• Install the AD converter in the rack by using four screws (standard

accessory).

Caution:

• Before mounting make sure that the rack mounting brackets on both

sides the unit are fixed with screws.

• Do not block the ventilation opening or slots on the cover to prevent

the appliance fi-om overheating. Always keep the temperature in the rack

within 45®C (

113*^19.

• Secure the rear of the appliance to the rack by using additional

mounting brackets (procured locally) if the rack is subject to vibrations.

3 1