Panasonic WZ-AD96 - Manual (Page 15)

G e t t i n g S t a r t e d
FPEQ
M.lk [ZZll88-2kl
48k CDl 96k I
□
I CH-SEL 1
Notes:
• Out channel selection is not available if 44.1 kHz or 48
kHz is selected for the reference source.
• When the DUAL AES/EBU card is installed in the unit, Out
channel selection is also available. Selecting 5-8 will result
in that contents of the channel
5-8 are supplied to both the
output channel 1-4 and 5-8 of the card.
(D < OUT Channel Selection> Indicator [44.1k 88.2k 48k
96k]
The upper LED (44.1 kHz, 88.2 kHz) lights in green when a set of channel 1-
4 is selected, or the lower LED (48 kHz, 96 kHz) lights when a set
of channel 5-8 is selected.
® Button [CAL]
Calibration to the clock synchronization is carried out manually by
pressing this button. Digital outputs are mute during calibration.
CLOG«
cm CRYSTAl
CD EXT
I—I ERROR
@ Indicator (CRYSTAL EXT ERROR]
Error indicator lights in red during calibration for about 1 second.
® Button [SHIFT]
Press this button to enter or to quit the shift mode.
® < Shift Mode > Indicator [24bit 20bit l6bit]
All three indicators light during the shift mode.
□
LENGTH
m] 24bit
nH 20M
□ 16W
I SHIFT I
REAR PANEL
For AD96
® Analog Input connector [1-8 ANALOG INPUT -1-4 dB lOkfl (BAL)]
These XLR connectors accept analog signals supplied by external devices.
Input level is -1-4 dB for each channel. See the next page.
For AD96M
® Analog Input connector [1-8 ANALOG INPUT -60 dB to +4 dB lOkQ
(BAL)]
These XLR connectors accept analog signals supplied by external devices.
Input level is adjustable with a trimmer from -60 dB to -1-4 dB for each
channel. See the next page.
1 6