Recalling a station m, Radio operation, Radiobetneb – Panasonic RFB55 User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

a
Radio Operation
)ii'-ia 1
P i i 1 1
r U L L
2 3 4 5 6 7 8 9
42
1
REAL/DUAL
(|l[)l-STANDBY-©HWS TIMER
I FM
r LW ni MW^li sw 1
•ATS
•ATS
•ATS '^'■NXMETÉR
2
<>
imd
1 0 Ö
M 1 2 C3] 4 5
V
•After the first 9 positions are fiiied in the FM
and SW bands, “PI” changes to “P2” and a
further 9 positions become available for a to
tal of 18 positions.
•When aii the positions are fuli, “FULL” is dis
played if [• TIME SET, M] is pressed: You
can replace a station at this stage by holding
down the numbered button of the position to
be replaced for about two seconds. The new
station takes that position and the old one is
cleared. E
■ Recalling a station
m
Example: To recall the station in position 3
1. Select the band of the station to be
recalled.
2. Press the numbered button for the
position the station is stored in.
(Press [P1/P2] when recalling FM
or SW stations.)
The station tunes in instantly. The display
shows the frequency and the memory
position.
Radiobetneb
• Nachdem die erstdn 9 Speicherplätze für den LIKW-
und den KW-Bereich mit Festsendern beiegt wor
den sind, weehseit die Anzeige „Pi“ auf „P2“, und
weitere 9 ¡ Speicherpiätze stehen zur Verfügung
(insgesamt 18 pro Weilenbereich)^ =
•Nachdem aile Speicherplätze mit; Festsendern
belegt worden sind, erscheint die Anzeige „FULL“,
wenn [• TIME SET, M] erneut gedrückt wird, in
einem soiohen Fail kann ein bereits eingespeiohért-
er Sender durch den momentan abgestimmten
Sender ersetzt werden, indem die Zifferntaste für
den betreffenden Speicherplatz ca. 2 Sekunden
lang gedrückt gehalten wird. Dadurch wird der bi
sherige Festsender gelöscht und der neue Sender
eingespeiohert. H
■ Abrufen von Festsendern EI
Beispiel:
Abrufen des Festsenders
In
ßpeicher-
........ platz 3
1. Den Wellenbereich des gewünschten
Festsenders wählen.
2. Die Zifferntaste für den entsprechenden
Speicherplatz drücken. (Beim Abrufen
eines UKW- oder KW-Senders [P1/P2]
nach Erfordernis betätigen.)
Der gewählte Sender wird unmittelbar abge
stimmt. Seine Frequenz sowie die Nummer des
Speicherplatzes erscheinen auf dem Anzei
gefeld.