Panasonic PT-AE1000 - Manual (Page 10)

Switching the projector on/of
peripheral device.
>n page 45.
ily to the audio reproduction system.
To video
output
To S-video
output
) player DVD player
f
— RGB signal cable
T To RGB output
■ performance.
adapter, but some equipment may not
;ee “Serial terminal” on page 46.
T and the ASPECT menu is set to
Ensure all the input devices are connected and turned off before connecting the Mains lead.
I Connecting
Make sure using the Mains
lead which is provided with
the projector.
1. Ensure the shape of the
mains plug and the AC
IN connector on the side
of the projector match, then push the plug all
the way in.
2. Connect the
Mains lead
to a wall socket.
■ Disconnecting
Make sure the MAIN POWER is switched off.
1. Hold the plug and unplug the
Mains lead
from the wall socket.
2, Hold the plug and unplug the
Mains lead
from the AC IN connector on the side of the
projector.
NOTE:
• Do not force the connector as this may damage the projector and/or the mains lead.
• Dirt or dust build-up around plugs may cause fire or electrical hazards.
• Switch off the power to the projector when not in use.
Indicator status Status
No illumination or flashing The MAIN POWER is switched off.
RED Lit The MAIN POWER is switched on and the projector is standby.
GREEN
Flashing The POWER is switched on and the projector is getting ready to project.
Lit The projector is ready to project.
ORANGE
Lit The POWER is switched off and the projector is cooling the lamp.
Flashing
The POWER is switched on again when cooling the lamp and recovering
to projection mode. Recovery may take a while.
NOTE:
• While the projector is cooling the lamp, do not switch the MAIN POWER off or unplug the Mains lead.
• The electric consumption in standby mode is 0.08 W,
E nglish -19