Panasonic SCAK75 - Manual (Page 47)

i »■ * «■ i * » r* Ÿ f t V * '* 1 #■ # * % %■ i 1Î ^ < ^ ♦ f !
i. *■ m M 11 f * *. i. * t- # ■ # t- *:
* i -^.. j i p*:i é**.*.i: i là«* # *■■*■*■ f Ilf If ¿ i * ÏÏ
♦ * * * * *■»#■#»■♦?■• I 1. «■ i # i # * ÿ ». f + # » f » t :* i ■»■*? ♦ I о * . о * f ♦ Î f f *».#.# ■
Problem Probable cause(s) Suggested remedy
Reference
page(s)
When there is a television set nearby
The picture on the TV
disappears or stripes
appear on the screen. The location and orientation of the unit’s FM
antenna are incorrect.
If you are using an indoor antenna, change
to an outdoor antenna.
8
The wiring at the back of the system is
unsuitable.
Separate the antenna wire of the TV set
from the system.
When listening to tapes
Sound is iow, intermittent,
poor quaiity, noisy,
scratchy, or unsteady.
Heads are dirty. Clean the heads. 47
The deck does not enter
the recording mode. The erase-prevention tabs have been
removed from the cassette.
Attach tape to cover the space left by
removal of the erase-prevention tabs.
44
While listening to CDs
The display does not show
the correct indication. CD
play does not start when
you press the play button.
The CD label is facing left. Set the CD with the label facing to the right. 14
The CD is dirty. Wipe the CD with a soft cloth. 44
The CD is scratched. Replace the CD with a new one.
The CD is badly warped.
The CD is nonstandard. Replace the CD with a different one. 44
There is condensation inside the CD
changer. Wait for 60 minutes before using the CD
changer.
A certain music passage
can’t be played correctly. The CD is dirty. Wipe the CD with a soft cloth. 44
The error message “DISC
TAKE OUT” appears on
the display and the
changer stops operating.
A disc has been put in the slot of the CD in
play.
Remove the CD whose number is displayed
and close the rack panel.
The CD does not return to
its slot.
(“DISC TAKE OUT”
appears on the display.)
Because of light or noise, the changer has
detected a CD in the slot of the CD being
played, even though it is empty.
Check whether another CD is in the slot or
not, if not, hold down the ■ (stop) button for
4 seconds.
The changer will then eject the CD. If this
proves to be ineffective, contact the place of
purchase.
/
While using the remote control
The system cannot be
operated with the remote
control. The batteries are installed in the reverse
polarity.
Re-insert the batteries in the correct
polarity. 5
The batteries are run-down. Replace the batteries with new batteries. 5
If 1-he surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a soap*
and-water solution or a weak detergent sofution.
For a cleaner crisper sound
We recommend that you periodically clean parts (the shaded portion
in the figure below) the tape contacts like the heads.
Do not use any liquid other than alcohol for head cleaning.
• Never use alcohol, paint thinner, or benzine to clean this unit.
• Before using a chemically impregnated cloth, read the instructions
that came with the cloth carefully.