Panasonic SCAK75 - Manual (Page 12)

Presetting radio broadcasts
ii^/1 / )i 1111 i )
I I / ( ; 'I (_/ ; ( )_
k I
i 4
< \/™ e / t ™ eaoj \ / tune / timeadj /\\
/■>/
; (
n n
U U .
MEMORY/CURSOR
n n t
U U . I
hll
) I
i ~ t n n
O D. Z j
Preset channel
► Up to 12 stations can be set in each band with the automatic or
manual memory presetting.
Mf broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the system or remote control
unit.
►You can preset just those stations you like. (See “Presetting only
your favorite stations” below.)
Press TUNER BAND to select the band.
The power will come on automatically.
Every time you press the button; “FM”<—>“AM”.
n Press TUNE MODE to select “MANUAL”.
Every time you press the button; “MANUAL”^—^“PRESET”.
Press V or A until the display shows the fre­
quency from which you want to begin auto­
matic memory presetting.
Tips on tuning in radio stations
® Hold down either arrow button until the frequency numbers
start scrolling.
Continue to hold the button.
@ When near to the frequency you are looking for, press the
button repeatedly until the station is tuned in.
Fj Press and hold MEMORY until the frequency
begins to change.
This will start presetting automatically. When finished, the radio
will tune in the last station memorized.
If auto presetting is not possible because radio signals are
weak or for some other reason, do the following.
Presetting only your favorite stations
Preset the stations one at a time.
1. Perform step 1 above. Then, press MEMORY (“MEMO” flashes)
and select a station with v and a .
2. While “MEMO” is flashing press MEMORY again and select a
preset channel with v or a .
3. Press MEMORY to preset the station.
Memory retention
The memory can retain presetting for up to two weeks after being
disconnected from the power source.
FM allocation settings:
The FM frequency step is set to 0.2 MHz at the time of shipment.
By adjusting the allocation as shown below, you can enable the sys­
tem to receive FM broadcasts allocated in 0.1 MHz steps.
1. Press and hold TUNER BAND for approximately 5 seconds.
The frequency display will be returned to the minimum frequency
of the FM band and the display will begin to flash.
Keep holding for approximately 5 more seconds.
2. When the display stops flashing and indicates a different fre­
quency number (the frequency step is changed to 0.1 MHz.), re­
lease TUNER BAND.
To return to the original frequency, repeat steps 1 to 2 above.
After changing the “allocation” setting, the frequencies you previous­
ly preset in the memory will be cleared.