N press deck 2 ^ open and insert the tape, Press rev mode to select the reverse mode, Select a radio station – Panasonic SCAK75 User Manual
Page 33: Pi press • rec/stop to start recording, To stop recording, To start recording on the reverse side, To record from a specific point on a tape, To cut an unnecessary part whiie recording, Press fm iwode/bp while recording, Recordmg from radio broadcasts
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recordmg from radio broadcasts
□
I I lol
t i l l
n Í
U > )
>1)1
• 1 ) 1
I
L I > i_
n Press DECK 2 ^ OPEN and Insert the tape.
Close the holder by hand.
Tape direction is autonnatically set to
Press REV MODE to select the reverse mode.
Every time you press the button;
One side is recorded, then recording stops auto
matically.
c:^y. Both sides {front side^reverse side) are recorded,
then recording stops automaficaily.
Select a radio station.
page 13, steps 1 to 3).
PI Press • REC/STOP to start recording.
If you selected in step 2, the direction will automatically
change to when recording starts.
To stop recording
Press • REC/STOP again.
Recording can also be stopped by pressing M.
To start recording on the reverse side
Load a tape and change the tape direction as following.
1. Press TAPE DECK 1/2 and select tape deck 2.
2. Press ■< and immediately thereafter ■. The tape direction will be
shown as
To record from a specific point on a tape
Before recording, advance the tape to the point from where you
want to start recording.
To cut an unnecessary part whiie recording
1. Press # REC/STOP during the unnecessary part. The cassette
deck will go into the stop mode.
2. Press # REC/STOP to resume recording again. Recording will
continue in the same direction as before.
When recording an AM broadcast, sound is momentarily interrupted
when you start and stop the recording.
To reduce noise while AM recording
(Beat proof function) d
Press FM iWODE/BP while recording.
Each time you press the button, BP 1 and BP 2 will be displayed
alternately.
Select the position with the least noise.
C
.0
s
Q)
&
tn
.c
o
u
Q)