Panasonic NV-HD620 - Manual (Page 30)

Search Functions
Searching Timer-Recorded
Programmes
(Programme List Search)
Searching Using the Programme List Search Function
When timer programmes are recorded by this VCR, the
VCR stores the programming details, and the programmes
are selected and searched by the programme list
search function.
Preparations
•Confirm that the TV is on and the VCR viewing channel
is selected.
• Press the VCR/TV button to select the VCR operation
mode. (NV-HD620EA only)
•Release the standby status for timer programme
Displaying the PROGRAMME LIST
SEARCH Screen
Press SEARCH, search
O)
On Screen Display
1 - .............................^
tow trOS^
i : . clt .iLIt* .*»HT
tow 3 ?
V., ■ ukkiT-kLJ
(During a search)
•The details of the timer-recorded programmes on this
video cassette are displayed on the PROGRAMME LIST
SEARCH screen in the sequence in which the
programmes were recorded.
•When no further operations are undertaken for about 3
or more seconds, the search for the last timer-recorded
programme is commenced.
•Upon completion of the search, playback starts from the
searched point on the tape.
Searching other programmes
Press SEARCH several times to select the programme
which is to be searched.
SEARCH
O)
•When SEARCH is pressed once, the timer-recorded
programme which was recorded last is selected. Each
time SEARCH is subsequently pressed, the programme
before (or above on the list shown on the screen) is
selected.
• If SEARCH is pressed again when the top programme is
selected, the bottom programme will be selected.
•Another programme can be selected by pressing
SEARCH even after a search has been commenced.
To stop the search at any time
Press MENU and clear the PROGRAMME LIST SEARCH
screen.
Notes:
•This function does not work during timer recording
standby mode.
•This function works only for video cassettes containing
timer-recorded programmes.
•Since this function works only for the currently loaded
video cassette, all the programming list details will be
cleared when the video cassette is ejected or
replaced with another one. At times like this, use the
VHS index search system or the intro-jet scan function.
(See page 31.)
•The programme list search function may not work
properly when recorded programmes run for 15 minutes
or less.
• Ensure that TAPE SELECT for OPTION on the OSD
MENU is set correctly, as otherwise, this function will not
operate correctly.
•When SEARCH is pressed during playback, playback is
stopped immediately, and the PROGRAMME LIST
SEARCH screen appears.
•Up to 8 programmes can be displayed on the
PROGRAMME LIST SEARCH screen. If the timer is
used to record more than 9 programmes, the oldest
programme will be deleted on the PROGRAMME LIST
SEARCH screen, and a new timer-recorded programme
will be entered and displayed.
•This function may not work properly depending on the
tape position when you press SEARCH.
•This function may not work properly when for example,
you try to record over a programme with another
programme that is timer-recorded on the same portion of
the tape.
30