Panasonic NV-HD620 - Manual (Page 14)

Setting the Remote Controller for Operation of
your TV
You can operate the TVs of the manufacturers listed
below with the remote controller after setting it.
2
2
SetVCR/TV
switch to TV
for using
N/ and
the numeric
buttons.
Preparation
Install the batteries in the remote controller.
Operations
1 Turn on the TV.
2 Press OFF or slowly and
accurately while holding down
PRESET. Each time either or
is pressed, the number changes in the
following sequence.
•When is pressed; 1^2^...19^1-»...
•When is pressed; 1 9-
h . 18^ ...1-^19^...
•The TV power is turned off when you reach the
number matching the number corresponding to the
manufacturer of your TV. The manufacturer
number is not displayed.
•Set VCR/TV switch to TV, otherwise you cannot
select the programme position of the TV using v
/N and the numeric buttons of this remote
controller.
Note:
Some TV models cannot be operated using this remote
controller.
When the TV manufacturer is Panasonic/National,
MITSUBISHI, SANYO, GOLDSTAR or SAMSUNG:
If, after the settings, none of the functions except for the
one which turns off the power are operational, repeat
step 2, and perform the settings again using a different
manufacturer number.
1 Panasonic/National
2 Panasonic/National
3 Panasonic/National
4 Panasonic/National
5 SONY
6 TOSHIBA
7 JVC
8 HITACHI
9 MITSUBISHI
10 MITSUBISHI
11 SHARP
12 PHILIPS, SAMSUNG
13 NEC
14 SANYO
15 GOLDSTAR
16 GOLDSTAR
17 SAMSUNG
18 SAMSUNG
19 SANYO
14