Panasonic NV-HD620 - Manual (Page 13)

Manual Tuning Procedure
1 Press MENU.
2 Select TUNER PRESET by pressing A or T and
ENTER.
3 Select CH by pressing A or ▼ then select the channel
number you want tuned by pressing ◄ or ►.
4 Confirm that CLEAR is set to OFF.
5 Select SEARCH by pressing A or T then press ◄ or
►
.
On Screen Display
n.
iA
SEARCH CHS . SEARCH 2
B№);MENU
■ ^ _______________ ___ 1
6 If the desired TV station has not been tuned, press ◄
or ► again.
• Press MENU and repeat steps 3-5 for each programme
position you want to tune to a station.
•To exit, press MENU three times.
Direct Tuning
1 Repeat steps 1-4 in Manual Tuning.
2 Select SEARCH by pressing A or ▼,
3 Using the numeric buttons on the remote controller
(Ensure that VCR/TV switch is set to VCR.), enter the
same number as the number of the channel to be tuned.
For the 5A and 9A channels, input the following
numbers: 90forCH-5A, 91 forCH-9A.
• For other channels that require tuning, repeat steps 3-4
in Manual Tuning and steps 2-3 above.
•To exit, press MENU twice.
Fine Tuning Procedure
1 Press MENU.
2 Select TUNER PRESET by pressing A or ▼ and
ENTER.
3 Select CH by pressing A or ▼ then select the
programme position by pressing ◄ or ►.
4 Select FINE by pressing A or ▼.
5 Press ◄ or ► to obtain the best tuning condition.
On Screen Display
CH 1 AFC: EHTER
FINK + -mOD »<0:WENU
•To return the tuning to its former state, press ENTER.
6 Press MENU.
Blanking of Unused Programme
Positions
1 Press MENU.
2 Select TUNER PRESET by pressing A or T and
ENTER.
3 Select CH by pressing A or T then select the
programme position by pressing ◄ or ►.
4 Select CLEAR by pressing A or T .
5 Select ON by pressing ◄ or ►.
• Repeat steps 3-5 for other unused programme
positions to skip during the selection of programme
positions.
•To cancel the blanking of a programme position,
select that programme position then select CLEAR
OFF.
6 Press MENU twice.
§
O)
.c
S
0
CO
1
13