Panasonic NN46240-710 - Manual (Page 33)

Nortel Secure Router 8000 Series
Troubleshooting - VPN___________ 1 L2TP troubleshooting
Item Sub-item Description
Bind the VPN Bind the corresponding VPN in the VT
view.
Configuring L2TP Enable L2TP L2TP can be configured only after L2TP
is enabled.
The source interface
of the tunnel on the
LAC side You can specify the loopback interface,
Ethernet interface, and GigabitEthernet
interface as the source interface of the
tunnel.
The name of the
tunnel
The name of the tunnel on the LAC side
must be consistent with the name of the
remote end to receive the tunnel on the
LNS side.
The authentication of
the tunnel
The configuration for whether to enable
tunnel authentication on the LAC side
must be the same as that on the LNS side.
The password of the
authentication of the
tunnel
After tunnel authentication is enabled, the
passwords on both the LAC and LNS ends
must be consistent.
The list separator of
the user postfix
If you establish the connection with the
L2TP through the domain, you need to run
the l2tp domain command to configure
the separator of the user postfix.
The static route on the
LAC side When the LNS side uses the IP address of
the loopback interface as the IP address of
the L2TP group, you must configure the
route to be reachable to the LNS loopback
interface on the LAC side.
The request for the
connection with the
L2TP allowed on the
LNS side If the number of the L2TP group is 1, you
need not specify the remote name. If you
specify the remote name in the L2TP
group 1 view, the L2TP group 1 does not
work as the default L2TP group.
The IP address of the
L2TP group bound on
the LNS side
You can use the IP address of the Ethernet
interface, GigabitEthernet interface, and
loopback interface as the IP address of an
L2TP group. After the loopback interface
is bound, it cannot be used for other
services.
The user
authentication on the
LNS side
After LCP renegotiation is configured on
the LNS side, you need to configure the
PPP authentication mode on the
corresponding virtual interface template.
Otherwise, the user cannot pass the
authentication.
Issue 5.3 (19 January 2009) Nortel Networks Inc. 1-13