Panasonic NN46240-710 - Manual (Page 104)

Nortel Secure Router 8000 Series
Troubleshooting - VPN___________ 3 BGP/MPLS IP VPN troubleshooting
Item Description
Alarm message Error: VPN-Target list is full
Meaning Targets are full and you cannot configure more.
Possible cause You can configure up to 16 targets only.
Solution Delete one or more existing VPN targets.
Item Description
Alarm message Warning - Maximum Route Limit xxx Reached - Allowing Route to be
added
Meaning In the VPN1 routing table, the number of routes reaches the limit. Routes
can be added until the limit defined in the paf file is reached.
Possible cause The value of number specified in the routing-table limit number
simply-alert command in the VPN view is too small.
Solution Increase the number in the routing-table limit number simply-alert
command.
Item Description
Alarm message Warning - Threshold level xx Percent reached - Route addition denied
Meaning In the VPN1 routing table, the number of routes reaches the limit. Routes
can be added until the threshold defined by the routing-table limit
command is reached.
Possible cause The value of alert-percent set in the routing-table limit number
alert-percent command in the VPN view is too small.
Solution Increase the alert-percent in the routing-table limit number alert-percent
command.
Item Description
Alarm message Label allocation : label is used out
Meaning No more labels can be allocated.
Possible cause The number of applied labels reaches the maximum threshold defined in
the paf file.
Solution Increase the number of allowed labels in the paf file.
Issue 5.3 (30 March 2009) Nortel Networks Inc. 3-25