Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 4)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 4
Revision History
Revision Revision Date Description
D January, 2014

Updated guidance that SkyView does not support
pressure altitude output to certain transponders
that are supported in Dynon EFIS units. (Page 13)
C September 2013

Updated guidance for use of capacitive fuel level
sensors (voltage output) SV-EMS-220 Pins 20 and
21.

Minor terminology revisions on SV-EMS-220
connected sensor descriptions.

Updated all references to SV-EMS-220 Pin 23 to
reflect that it is now a General Purpose Input,
Type C (was Type A).

Removed Page 45 (this page intentionally left
blank)
B August 2013

Removed guidance for SkyView COM Radio. Full
information on SkyView SV-COM-C25 is now
available.

Added EMS Sensor Types conversion to SkyView
Sensor Types.

Updated SV-EMS-220 C37 P24 to mention GRT
CS-01 rewiring required.

Corrected that MS28034-3 sensor is not
supported in SkyView (it is supported).

Additional non-Dynon sensors not supported in
SkyView.

Updated guidance on SV-EMS-220 Pin 23;
enabled as an Enhanced General Purpose Input
Pin after installing the June 2013 (or later) version
of the Engine Sensor Definition File.
A January 2013 Initial release