Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 11)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 11
SkyView Compatibilities with Dynon Avionics EFIS and EMS Systems
SkyView is compatible with the following Dynon accessories that may be part of a Dynon
Avionics EFIS or EMS system:
All engine monitoring sensors sold by Dynon – CHT, EGT, oil temp, oil pressure, fuel pressure,
amps, fuel flow, etc.
Autopilot servos
9 10
Angle of Attack / Pitot Probe / Boom (heated and unheated versions)
Capacitance to Voltage Converter
EMS Wiring Harness
11
Encoder Serial-to-Gray Code Converter Module
OAT Probe for EDC-D10A – 100433-001 (sold since 2005) and OAT Probe for EMS – 100433-
000
12
9 For servos to be compatible with SkyView requires the Dynon Avionics EFIS must be at least firmware v5.2.
10 To communicate with servos, a Dynon Avionics EFIS’ DSAB used only one of the servo’s two communications
buses (Blue and Green wires). SkyView Network implements the second communications bus on a servo –
Blue+Green wires, and White/Blue+White/Green wires.
11
Some modifications required to work with SkyView
12
Some modifications required to work with SkyView