Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 33)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 33
EMS-D10 / EMS-D120 / FlightDEK-D180 Sensor Type
Description in Manual SkyView Sensor Description
SENSOR INPUT MAPPING
Oil Temperature – Type 10
UMA 1B1 (1/8-27 NPT)
UMA 1B3 (5/8-18 UNF)
These sensors are not supported in SkyView
Guidelines for Conversion of HS34 HSI Expansion ModuleD25 Male Connector to
SV-HARNESS-D37 and SkyView SV-EMS-220 Main Sensor Harness
As previously mentioned, the HS34 is not compatible with the SkyView system. This chart
explains the signals and wires that may be rerouted on the existing HS34 harness for conversion
to a SkyView Display SV-HARNESS-D37 and SkyView SV-EMS-220 Main Sensor Harness. Note
that Dynon has never supplied a harness for HS34, so there are no standardized wire colors –
you will have to match pin numbers with wire colors.
Note – as previously mentioned, the Analog Resolver, DME, Marker, etc. inputs and outputs
present on the HS34 are not available in SkyView.
HS34
Male
Connector
Pin No.
HS34 Male Connector
Function
Notes for conversion to
SV-HARNESS-D37
and
SV-EMS-220 Main Sensor Harness
1
Serial 1 RX (PC
updates and second
serial port)
If this wire was used for connection to PC, no longer required; remove
this wire.
If this wire was used for connection to serial GPS or serial NAV radio,
reroute this wire to SkyView Display Serial Port RX.
If this wire was used for connection to ARINC-429 GPS, reroute this wire
to SV-ARINC-429 Pin 3 (SERIAL RX, AVIATION FORMAT ONLY FROM
CONNECTED ARINC-429 GPS
2
Serial 2 RX (SL30, GPS,
etc.)
If this wire was used for connection to serial GPS or serial NAV radio,
reroute this wire to SkyView Display Serial Port RX.
If this wire was used for connection to ARINC-429 GPS, reroute this wire
to SV-ARINC-429 Pin 3 (SERIAL RX, AVIATION FORMAT ONLY FROM
CONNECTED ARINC-429 GPS
3 DSAB A
Not used in SkyView system.
Remove this wire.
4
MASTER POWER (10-
30v, 250 mA
maximum @ 12V)
Not used in SkyView system.
Remove this wire.
5
GP OUTPUT 1 (not
currently supported) Not used in SkyView system.
Remove this wire.