Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 31)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 31
EMS-D10 / EMS-D120 / FlightDEK-D180 Sensor Type
Description in Manual SkyView Sensor Description
SENSOR INPUT MAPPING
Fuel Pressure Sensor – Type 1
Dynon P/N 100411-000
(Legacy 0-30 PSI carbureted)
0-30 PSI FLUID PRESSURE (100411-000)
Fuel Pressure Sensor – Type 2
Dynon P/N 100411-001
(Legacy 0-80 PSI injected)
0-80 PSI FLUID PRESSURE (100411-001)
Fuel Pressure Sensor – Type 3
GRT LPS-02
(remove the external pull-up resistor)
This sensor is not supported in SkyView
Fuel Pressure Sensor – Type 4
Stewart Warner 82504-F
STEWART WARNER 15PSI (82504-F)
Fuel Pressure Sensor – Type 5
Dynon P/N 101715-000
Kavlico 5 PSI Gravity Feed
KAVLICO 5PSI FLUID PRESS (101715-000)
Fuel Pressure Sensor – Type 6
Dynon P/N 101690-000
Kavlico 15 PSI Gravity Feed
KAVLICO 15PSI FLUID PRESS (101690-000)
Fuel Pressure Sensor – Type 7
Dynon P/N 101716-000
Kavlico 50 PSI Gravity Feed
KAVLICO 50PSI FLUID PRESS (101716-000)
GP Temp Sensor – Type 1
Dynon P/N 100433-000 (2-wire)
Dynon P/N 100433-001 (3-wire)
DYNON 2-WIRE OAT (100433-00X)
GP Temp Sensor – Type 2
GRT OAT-01
This sensor is not supported in SkyView
Manifold Pressure – Type 1
Dynon P/N 100434-000
(C37 P26 only) PRESSURE – 100434-000
Manifold Pressure – Type 2
(GRT MAP-01 or MAP-02)
This sensor is not supported in SkyView
OAT Sensor – Type 1
Dynon P/N 100433-000 (2-wire)
Dynon P/N 100433-001 (3-wire)
DYNON 2-WIRE OAT (100433-00X)
OAT Sensor – Type 2
GRT OAT-01
This sensor is not supported in SkyView