Dynon Avionics D100 Series to SkyView Conversion Guide - Manual (Page 22)

D10 and D100 Series Conversion To SkyView Guide – Rev D Page 22
EMS D37
Female
Connector
Pin No.
EMS D37
Connector Wire
Color
EMS Function
SV-EMS-220
Function Sensor / Wiring Conversion To
SV-EMS-220
9 BROWN/BLUE CONTACT 1
GENERAL
PURPOSE INPUT
5 (TYPE A)
No changes required.
10 BROWN/YELLOW CONTACT 2
GENERAL
PURPOSE INPUT
6 (TYPE A)
No changes required.
11 ORANGE SERIAL A TX
GENERAL
PURPOSE INPUT
7 (TYPE A)
New capability – now a General
Purpose input. Cut off the 9-pin
connector to use this wire.
If connected to EMS Streaming
Data, reroute this wire to
SkyView Display Serial Port TX.
12 YELLOW SERIAL A RX
GENERAL
PURPOSE INPUT
8 (TYPE A) New capability – now a General
Purpose input. Cut off the 9-pin
connector to use this wire.
13 BLACK GROUND
SIGNAL
GROUND
No changes required.
14 YELLOW FUEL FLOW FUEL FLOW 1 No changes required.
15 RED +12V OUTPUT +12V OUTPUT No changes required.
16 BLACK GROUND
SIGNAL
GROUND
No changes required.
17 BLACK GROUND
SIGNAL
GROUND
No changes required.
18 WHITE/RED +5V OUTPUT
+5V OUTPUT
(0.5A MAX)
Remove any resistors
connected between this pin
and other pins (pull-ups), esp.
Pin 4, Pin 22, Pin 23 (EMS
General Purpose Inputs – see
notes on those pins.)