WEATHER GUARD Model 222-3 Accessory Cross Member, Minivan - Manual (Page 4)

4
ASSEMBLY INSTRUCTIONS
"A"
Figure 4. Stand Placement
STEP 3. Locate the Rear Crossmember Assembly on the roof centered side to side at the dimension shown at right.
Mark through the obrounds in the Mounting Brackets at the point where the Mounting Bracket radius meets the roof.
STEP 4. Locate the Front Crossmember Assembly centered side to side from back edge of Rear Stand to back edge
of Front Stand at the dimensions shown at right. Again, mark through the obrounds in the Mounting Brackets.
Airfoil to face
forward
Figure 5. Stand / Crossmember Spacing
Standard length vans - 74-3/8"
Extended length vans - 86-3/8"
STEP 2. Adjust then tighten the Stand Assemblies to the following dimensions:
Chevy Astro/GMC Safari:
Front Crossmember "A" - 1-1/16"
"B" - 56-7/8"
Rear Crossmember "A" - 5-7/8"
"B" - 47-1/4"
Ford Windstar:
Front & Rear Crossmember:
"A" - 7-5/8"
"B" - 43-3/4"
"A"
"B"
Dimension "A" should center the Stands
side to side. Adjust both Stands accord-
ingly if they are not even.
Figure 3. Stand Adjustment
Dimension "A" - Stand placement
ahead of rear edge of roof
Astro/Safari - 3"
Windstar - 1-1/4"