WEATHER GUARD Model 9012-3-01 Cab Command Center, 13 in - Manual

1
INSTALLATION MANUAL
Cab Command Center
Model Number 9012-3-01
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
WWW.WEATHERGUARD.COM
VAN STORAGE SOLUTIONS
FOR THE WAY YOU WORK TM
*24-0303* Part No. 24-0303 REV. D ECN 5305 04/13
• Check fit of Cab Command Center side to side between the seats and front to back between the
bulkhead and dashboard/console before drilling mounting holes.
• Before drilling for the blind fasteners, check for fuel tanks, fuel lines, brake lines, electric wires, etc. to
avoid cutting or puncturing them.
• Power is faster — use an air or electric driver to assemble and install.
TOOLS REQUIRED
• 7/16 socket and driver
• 7/16 wrench
• 9/16 wrench
• drill, air or electric with 5/16 bit
• utility knife or 1-1/4" hole saw
• tape measure
• marker
• T-27 tamper-resistant (Torx ® ) bit
• TT-25 tamper-resistant six
lobe(Torx ® ) bit
PLAN YOUR VAN (TIPS FOR FASTER INSTALLATION)
BOLT KIT
DESCRIPTION QTY.
Nut, 1/4-20 nylon insert lock nut 3
Bolt, 1/4-20 x 3/4" hex washer head 7
1/4-20x1/2" Tamper-resistant Torx® 4
Blind fastener, 1/4-20 4
1/4-20x1" Tamper-resistant Torx®
mounting screw
4
Bolt, 1/4-20 x 2-1/4", black 1
Blind fastener installation tool 1
Be safe - always wear protective
eyewear to keep debris out of
your eyes when installing
WEATHER GUARD ® Van
Products.
CAUTION
Washer, 1/4" Flat 5
Bolt, 1/4-20 x 1-1/4" hex washer head 4
Foam Strip
1