WEATHER GUARD Model 8395-3-01 Jumbo Shelf, 59-1/2 in x 69-1/4 in x 24 in - Manual (Page 5)

PAGE 5 IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT US TOLL-FREE AT .800.456.7865 24-0245 REV. A 07/06
5 Three (3) Mounting Straps and Mounting
Strap Angles are provided. The Mounting
Straps can be bent to any shape and/or
used with the Mounting Angles. The
Mounting Straps should be attached to the
upper portion of the shelf unit in a manner
that would minimize movement of the unit
both front to rear and side to side. Attach
the Mounting Straps to the shelf unit through
existing holes (or drill new holes using a
5/16" drill bit) and fasten with three (3) 1/4-
20 x 5/8" Hex Head Bolts and 1/4-20 Nylon
Lock Nuts.
Fasten the other end of the Mounting
Straps by installing two to three (2-3) Blind
Fasteners in the wall or wall ribs at the
Mounting Strap locations by pre-drilling
1/8" holes and then re-drill the holes with
a 13/32" drill bit. Set the Blind Fasteners
in the holes per the INSTALLATION
INSTRUCTIONS FOR BLIND FASTENERS
on page 6.
Realign the Mounting Straps/Mounting Strap
Angles on top of the Blind Fasteners and
secure them to the wall or wall rib using two
to three (2-3) 1/4-20 x 3/4" Hex Head Bolts
and 1/4" Lock Washers.
INSTALLATION IS COMPLETE.
6 60" & 69" SHELF UNITS: Fasten the
Support Leg(s) in the center of the Shelf
using three (3) 1/4-20 x 3/4" Hex Head
Bolts, and 1/4-20 Nylon Lock Nuts.
Return to step 3.
NOTE: If installing doors on these units,
the Support Leg will need to be installed
off-center on the shelf. Positioning of the
Support Leg can easily be found by holding
the door in position on the shelf. The
notched out area of the hinge is where
to locate the Support Leg.
A second leg can also be fastened to the
back of the unit.
NOTE: The Center Support Leg may need
to be trimmed depending on application. If
the Support Leg is cut, remove burrs and
apply paint.