WEATHER GUARD Model 8395-3-01 Jumbo Shelf, 59-1/2 in x 69-1/4 in x 24 in - Manual (Page 3)

PAGE 3 IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT US TOLL-FREE AT .800.456.7865 24-0245 REV. A 07/06
CAUTION WARNING
All floor mounting bolts near the fuel tank area should be installed
from the underside of the vehicle, to guard against the fuel tank
being punctured in the event of a collision. This would mean not
using Blind Fasteners in this area. Holes in this area should be 5/16".
Ensure ample space in roof ribs and sidewall ribs for mounting
screws so as not to puncture exterior roof or wall.
Prior to drilling, so as not to cut or puncture fuel tanks, fuel lines,
brake lines, electric wires, etc., check behind or underneath drilling
and mounting locations.
To keep debris out of your eyes when checking the underside of
the vehicle, or when drilling, always wear protective eyewear.
1 After determining shelf spacing, assemble
each Shelf to the End Panels by pushing the
Shelf down, with the End Panel tab entering
the pierced opening on the Shelf edge.
Fasten the Shelves to the End Panels using
four (4) 1/4-20 x 1/2" Hex Head Bolts and
1/4-20 Serrated Nuts.
2
Attach the Floor Mounting Brackets to both
ends of the unit using four (4) 1/4-20 x 3/4"
Hex Head Bolts, 1/4" Flat Washers and
1/4-20 Nylon Lock Nuts.
NOTE: Floor Mounting Brackets can be
installed on the outside or inside ends of the
units. When installing two units side by side
or connecting to a Bulkhead, only one Floor
Mounting Bracket is required and should be
installed inside.
If installing more than one shelf unit, holes
in the end panels are provided for through-
bolting into the next unit for greater rigidity.