WEATHER GUARD Model 8395-3-01 Jumbo Shelf, 59-1/2 in x 69-1/4 in x 24 in - Manual (Page 4)

PAGE 4 IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT US TOLL-FREE AT .800.456.7865 24-0245 REV. A 07/06
3 Place the unit into your selected position
in the van, as close to the wall as possible.
Mark the four floor mounting holes where
the Floor Mounting Bracket comes in
contact with the floor ribs.
NOTE: 60" & 69" SHELF UNITS: Center
Support Legs have been added to these
units to strengthen these shelves because
of their length. (Go to step 6). If Center
Supports are needed, then mark their floor
mounting holes also. The Center Support
can face towards the unit or away from the
unit and should also contact the floor rib.
Remove the unit and pre-drill the floor
mounting locations with an 1/8" drill bit, then
re-drill the hole with a 5/16" drill bit. If there
is a floor mat, then Floor Mounting Spacers
are required. Cut the floor mat around the
5/16" holes with the 1" hole saw, allowing
Floor Mounting Spacers to rest against the
metal floor.
DO NOT DRILL THROUGH
THE VAN FLOOR WITH THE HOLE SAW.
4 Move the unit back into position. Fasten unit
to van floor using four (4) 1/4-20 x 1-1/4"
Hex Head Bolts, 1/4" Flat Washers, Floor
Mounting Spacers (if applicable), second set
of 1/4" Flat Washers and 1/4-20 Nylon Lock
Nuts. (See example bolting solutions below).
NOTE: One (1) Blind Fastener and Lock
Washer have been provided in case through-
bolting is impossible due to heat shields, floor
channels, fuel lines, etc. If Blind Fastener
installation is necessary, redrill the 5/16"
mounting holes with 13/32" drill bit. See
INSTALLATION INSTRUCTIONS FOR BLIND
FASTENERS on page 6.
TOP DOWN INSTALLATION THROUGH
FLOOR MAT AND VAN FLOOR
NOTE: The floor bolting
solution could be a variation
on any of these three examples
with or without the floor mat.
BOTTOM UP INSTALLATION THROUGH
FLOOR MAT AND VAN FLOOR
BLIND FASTENER INSTALLATION THROUGH
FLOOR MAT AND VAN FLOOR (SEE PAGE 5)