WEATHER GUARD Model 96102-3-01 Screen Bulkhead, Full-Size, Ford, GM - Manual (Page 7)

7
STEP 9: Install two (2) Blind Fasteners in the wall or
wall rib at the Driver Side Attacment Bracket locations
by pre-drilling 1/8" holes and then re-drill the holes with
a 13/32" drill bit. Set the Blind Fasteners in the holes
per the INSTALLATION INSTRUCTIONS FOR BLIND
FASTENERS below.
Realign the Roof Mount Brackets to their
marked locations and fasten them to the roof rib
using four (4) 1/4-14 x 3/4" Self-Drilling Screws
and 1/4" Flat Washers. Tighten all fasteners that
were left loose in Step 4.
WALL OR
WALL RIB
B-PILLAR
INSTALLATION INSTRUCTIONS
Place a drop of oil on the black oxide bolt before
assembling as shown on right. Place the Blind
Fastener in the hole and use a 7/16" wrench to
tighten black hex bolt until the Blind Fastener is fully
seated. When setting black hex bolt, it will start out
hard. As the Blind Fastener “bulbs” out it will get
easier, until it bottoms out or sets. Make sure the
Blind Fastener and Installation Tool do not turn during
installation.
INSTALLATION INSTRUCTIONS FOR
BLIND FASTENER
Flat Washer
9/16”Wrench
Installation Tool
Blind Fastener
Black Oxide Bolt
7/16”Wrench
(Or 7/16”Socket)
Part No. 24-0306 REV. D ECN 5282 03/13
INSTALLATION IS COMPLETE.