Citizen Systems iDP3240 - Manual (Page 73)

— 53 —
(3) Status caused by an error (when n = 3 is specified)
Bit Status Hex. Decimal
0 Unused (Fixed at 0) 00 0
1 Unused (Fixed at 1) 02 2
2 Undefined — —
3
Auto cutter error not occurred 00 0
Auto cutter error occurred 08 8
4 Unused (Fixed at 1) 10 16
5
Unrecoverable error not occurred 00 0
Unrecoverable error occurred 20 32
6
Auto recovery error not occurred 00 0
Auto recovery error occurred 40 64
7 Undefined (Fixed at 0) 00 0
Bit 3: If this error has occurred, remove the cause of the error,
and then DLE ENQ n (1 n 2) can be used to recover
from the error. However, it is not possible to recover from
any error due to a damaged cutter or circuit problem (e.g.,
broken wire).
Bit 6: If a head overheat error is detected, the printing is stopped
until the head temperature falls. At this time, bit 6 = “1”.
(4) Continuous paper detector status (When n = 4 is specified)
Bit Status Hex. Decimal
0 Unused (Fixed at 0) 00 0
1 Unused (Fixed at 1) 02 02
2,3
Paper found by Paper Near-end Sensor 00 0
Paper not found by Paper Near-end Sensor 0C 12
4 Unused (Fixed at 1) 10 16
5,6
Paper found by Paper-end Sensor 00 0
Paper not found by Paper-end Sensor 60 96
7 Unused (Fixed at 0) 00 0
[See Also] DLE ENQ, GS a, and GS r, “IDENTIFICATION OF SEND STATUS”
in APPENDIX 3