Citizen Systems iDP3240 - Manual (Page 35)

— 15 —
CAUTION:
• Always use the specified types of paper roll.
• Use of other types of paper roll may not be able to guarantee the specified print
quality or service life of the printer.
• Pull out the end of the paper roll up to the end of the upper cover.
The end of the paper should not go beyond or short of the end of the Top cover.
• When the paper roll is set, the paper end may sometimes come out folded over.
• If the paper roll is set inclined, pull the platen levers to adjust the position of the paper
roll.
• During printing, do not open the printer cover.
• If the paper fails to come out of the paper output slot, check to make sure the paper
end is properly cut, and then reset the paper roll. Also, after the printer has been used
for prolonged periods of time, the platen roller may have been covered with paper
debris, which may prevent the paper from coming out. If this happens, use a soft cloth
dabbed with ethyl alcohol to wipe the paper debris off the surface of the platen roller.
• When the paper fails to come out of the paper output slot, you can set the paper roll
using the procedure below:
1. While having the end of the paper roll inserted straight between the platen roller
and the head, press the FEED switch. The paper is pulled in by the platen roller and
guided into the auto cutter. (The of end of the paper will slightly stick out of the
paper output slot of the cutter.)
2. After closing the printer cover, the paper will be fed for a few more lines and then
automatically cut. Now, the printer is ready for printing. Remove the piece of paper
cut off.