Citizen Systems iDP3240 - Manual (Page 141)

— 121 —
For PAGE MODE:
• This command only maps the bar code, without performing a
printout. After the bar code is mapped, the dot next to the last
data item of the bar code is taken as the start position for the
next data mapping.
• If “d” is out of the range, the processing of the command is
aborted, and the subsequent data is handled as normal data.
In this case, the data mapping start position does not move.
• If the bar code is wider than the print area, the bar code is not
printed, but the data mapping start position is moved to the
left end of the non-print area.
[Default] The initial value is not defined.