Xpres Cut Lite - Manual (Page 19)

Operation
Note: Always check the force using the ‘Test Cut’ button before beginning to cut your transfer. To do
this press the ‘On/Off Line’ button to turn the cutter Offline (On/Off Line LED will be off).
Whilst the cutter is Offline press the ‘Cut Test’ button once. The cutter will now cut the pattern below:
If you weed away the square, you should be left with a lightly visible crosshair scoring in the backing
of the vinyl. This shows you have the correct force.
If you are unable to weed away the square you need to increase the force and repeat the Cut Test.
To increase the force open up the VLCD2 program (you may need to connect the cutter once more as
shown on page 6 and adjust the force in increments of 10g. Now click ‘Update’ to confirm the
change.
)
Now Click File > Print or the Print Icon ( ). Your design will begin to cut.
Once cut weed your design leaving your transfers ready to be pressed as shown below..
Tip: Start on a low force and work
your way up. This is to prevent
accidentally cutting through the vinyl
and damaging the blade and
cutting strip.
17