Xpres Banner - Manual

Phone:
Web:
E-mail:
Support: 01332 855 085
www.xpres.co.uk
[email protected]
www.xprestechnical.co.uk
®
STEP BY STEP
Step 1
Print banner to size required without any bleed on selected banner material.
Step 2
Once banner is dry, cut to the edge of the print using a sharp knife and safety straight edge.
Step 3
Turn the banner over so the print is face down (on a surface that will not scratch the print)
Step 4
Apply the T-BF40-25 tape to the outside cut edge, using the cut edge as a guide.
Step 5
Turn over the banner and
fit the eyelets using the XP3150 CStep-2 Eyelet
Machine. Making sure that the eye is fitted in the centre of the finishing tape.
Step 6
Banner is ready to be fitted.
Oakridge Park, Trent Lane
Castle Donington, Derby
DE74 2PY
PLEASE NOTE: The sellers and manufacturers maximum obligation shall be to replace any product
that has been proven to be defective. Neither the seller nor the manufacturer of the items required
when following these instructions shall be liable for any injury direct or consequential, arising out of the
use of, or inability to use this range.
Banner Instructions
ITEMS REQUIRED: MD-FL510 - Premium Banner
XP3150 - Eyelet machine with eyes
or Event Banner - MD-FL440
XP3150GW - Extra Eyes
when using finishing tape option T-BF40-25