Xpres SubliJet IQ EPSON Stylus PRO 4880/4450 (Windows Power Driver Setup): Sublimation Cartridge Quick Start Guide - Manual

Quick Start Installation of SubliJet IQ ® for the
EPSON Stylus ® Pro 4880
IMPORTANT:
Do not install Epson Inks provided with the printer. Please call Sawgrass Technical Support
if you need assistance installing the SubliJet IQ inks.
STEPS FOR INSPEcTINg SublIJET IQ cARTRIDgES FOR lOOSE chIPS:
INSTAllINg SublIJET IQ cARTRIDgES:
Rub chip with an eraser to determine
stability of attachment to cartridge.
Note: Use only a
pencil eraser to rub
chip surface to avoid
damaging chip.
1. Check the product package to ensure that the chip
remains attached to the cartridge itself and has not
dislodged in the plastic bag.
2. Determine if the chip is securely attached by tapping
the cartridge a few times on a hard surface, watching
to ascertain that the jolt does not dislodge the chip.
3. Once the cartridge is removed from the bag, rub an
eraser over the surface of the chip, to determine if it
remains stationary within it’s mounting slot. Use of
any item other than an eraser is not advised and can
damage the chip. (See photo @ far right.)
Rotate cartridge chIP lOcATION
& ORIENTATION
If you are replacing existing cartridges because they are empty or low,
please see the following instructions. If not, go directly to step #1.
1. Ensure the printer power is on.
Press the ink compartment cover
to release the latch and open the
cover.
NOTE: The LCD Panel will indicate the ink colors of the original
OEM ink configuration and not the SubliJet ink
configuration. (See Figure # 3 to the right.
When a cartridge is empty or extremely low, “INK OuT” will
display on the LCD panel. Raise the ink levers on either side of the
printer. The cartridge position indicator on the LCD panel will flash
on and off, indicating which cartridge is low or empty. Be sure you
have the correct color cartridge replacement for that position.
Position # 5: Empty
or Extremely low
4880 control Panel
5. After approximately 1 minute, ink lever messages will appear on
the LCD panel. The LCD will indicate that the printer recognized
“NON-gENuINE” ink cartridges.
Note:
Cartridge label must face left as cartridge is inserted into slot.
4. After all eight cartridges are installed, lower
the ink levers.
2.
Raise both ink levers. (Located @ the right side
of each ink cartridge compartment.)
3. Install the ink cartridges into the colorcoded
slots in the order that your system is currently
using, starting from left to right.
1 2 3 4 5 6 7 8
Menu
3sec.
NON-GENU I NE
1 2 3 4 5 6 7 8
Menu
3sec.