Xpres Cut Lite - Manual (Page 13)

Creating transfers
Now the vinyl is loaded in to the cutter correctly you can begin to create your transfer ready for
cutting.
Operation
If using a roll of vinyl, you can position the roll on the Support Bracket shown below to allow the vinyl
to unroll freely.
1. Open CorelDRAW and select a new page. Now click on the Text Tool ( ). With the Text Tool
Selected click once on screen - you will notice the cursor flashing on screen awaiting input. Enter
your text and select the relevant font. In this example we create the word ‘XPRES’ and use an Arial
Black font.
XPRES
2. Select the Pick Tool ( ), you can now adjust the size of the text by dragging the nodes (which
show when an item is selected).
You can also adjust the size accurately by typing in the required size in to the Object Size area on
the property bar.
Note: You adjust the height and width measurement independent of each by unlocking the
‘non-propertional scaling/sizing ratio’ padlock ( ).
Left click the node and drag to adjust the size
11