Xpres Cut Lite - Manual (Page 12)

Operation
Loading the media
. 1. Lift the 2 levers at the back of cutter to raise pinch rollers
2. Load your media on the platen and slide it under the pinch rollers from either the front side or the
backside.
3. Move the pinch rollers manually to the correct position. Be sure the pinch rollers are positioned
below the white marks as shown below. Always move the pinch rollers by hand from the back of
the cutter. Once in position use the clamps to lock the pinch rollers in to position.
Note: Be careful to position the pinch rollers so that they are not too close to the edges of the vinyl
and do not extend beyond the edges of the vinyl. If the pinch rollers are too close to the edge of the
vinyl this could cause the vinyl to come free from the pinch rollers if not positioned correctly i.e. if the
vinyl is not straight.
Correct
Incorrect
10