Welch Allyn CP 100 12-Lead Resting Electrocardiograph - User Manual - Manual (Page 38)

34 Chapter 4 Reviewing the ECG Settings Welch Allyn CP 100 Electrocardiograph
Item (in Figure 21 on page 33) Description
A. Patient data See “Reviewing the Patient Data Fields Available” on page 37.
B. ECG measurements Standard.
C. Interpretation (optional) See “Reviewing the Interpretation and Copy Settings for Auto Reports” on
page 36.
D. Report status label See “Reviewing the Interpretation and Copy Settings for Auto Reports” on
page 36.
E. 3 rows, 4 columns See “Reviewing the Format Settings for Auto Reports” on page 35.
F. Rhythm leads See “Reviewing the Format Settings for Auto Reports” on page 35.
G. Software version See also “Reviewing the Device Information” on page 29.
H. Device ID See “Device ID” on page 27.
I. Practice ID See “Practice ID” on page 27.
J. Date and time See “Set Date/Time” on page 27.
K. AC filter See “Mains Filter” on page 40.
L. Frequency range Lower limit: baseline filter on = 0.5, off = 0.3
Upper limit: muscle filter on = 35, off = 150
See
“Adjust Baseline Filter” on page 55 and “Adjust Muscle Filter” on page 55.
M Gain See “Adjust Gain” on page 55.
N. Paper speed See “Adjust Speed” on page 55.
O. Calibration pulse Amplitude reference — represents the current height of a one-millivolt signal.
Is adjusted for the selected gain:
5 mm/mV = 0.5 x
10 mm/mV = 1 x
20 mm/mV = 2 x