Smart Power Systems LR Series - Manual (Page 34)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 33 of 49
Step c: Press On/Off to
answer “yes” and
override the shutdown.
Example of Command & Control Center
in voltage range fault override confirmation
Figure 26
c. If your answer was “yes” in the previous step, the confirmation screen shown in
Figure 26 will be displayed. Again note the y and n labels below the Mode and
On/Off switches. Press the On/Off switch to answer “yes” and override the
shutdown. Press Mode to answer “no” and proceed to the oil temperature
display.
Note: If you override the system and command it to operate with voltage out of
range, the system may damage the equipment it is powering and you will void
the system’s warranty.
Special Operating Instructions
Cold Weather Procedure:
If the generator system is “started” when the hydraulic oil temperature is below 40°F, the
following message will be displayed on the Command & Control Center (reference Figure
27):