Smart Power Systems LR Series - Manual (Page 25)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 24 of 49
Step b: Hold Mode until
Amps Line 1 Blinks 88.
Release switch so 0Pt
and
AStr
appear.
Step c: Press On/Off
until the desired value
appears
Figure 12
Enabling Auto-Start Option
a. If the Command & Control Center is dark, press the Mode switch to put the
Command & Control Center into Normal mode.
b. Press and hold the Mode switch until the Amps Line 1 field begins blinking 88
(more than 10 seconds). Release the switch so 0Pt and AStr appear.
Reference Figure 12.
c. Press the On/Off switch until the desired value appears. A y means Auto-Start
is enabled, an n means Auto-Start is disabled.
d. Return to Normal mode by pressing Mode.
Operation
1.
The Command & Control Center will show the generator’s output voltage,
frequency, current, and system run time whenever the Command & Control Center
is in the Normal mode. To access Normal mode, press the Mode switch repeatedly
until the correct information is displayed (reference Figure 13).