Rice Lake Datamax-ONeil M-Class - Manual (Page 95)

M-Class 87
6.8 Downloading Firmware and Fonts
The operating programs and fonts for the printer are stored in Flash memory on the Main PCB. When program updates
and/or new features are added, they can be downloaded to the printer as follows:
1. Identify the new version for your model of printer from the Datamax Web site at
www.datamaxcorp.com and download
it onto your computer’s hard drive or a floppy disk.
2. Ensure that the printer is connected to the host, (via parallel port only) and that the power is ‘On.’ Using the DOS copy
command enter:
copy filename.dlf lpt1/b (non-display printer firmware is .dlf extension)
copy filename.zs lpt1/b (display printer firmware is .zs extension)
Note: Other programs (e.g., hyper-terminal and certain Windows
®
Driver programs) may also be used to download this file.
3. The READY light will flash during the download.
4. Following a successful download, the
STOP Light will illuminate then the printer will perform a ‘cold reset.’ The
previous printer setup will not be affected unless substantial firmware data structure changes have occurred. Print a
Database Configuration Label to verify your new firmware version.
Following an unsuccessful download, the
ERROR Light will illuminate then the printer will perform a ‘warm
reset’ (both the READY and STOP lights will be on during power-up initialization). The original firmware will
remain operational. If the printer fails to reset, toggle the power ‘Off’ and ‘On.’
Try re-sending the file to the printer. If the failure continues, check the following possible causes:
• An invalid or corrupted file is being downloaded - Ensure the file being downloaded is correct and applicable
for your printer model.
• Possible communications error - Check the cable connection between the host and printer and ensure that a
quality, shielded cable is used.
• Possible Flash memory problem - Call for service.