Rice Lake Datamax-ONeil M-Class - Manual (Page 85)

M-Class 77
Advanced Entry Calibration (continued)
Step Operator Action Displayed Message Comment
16 Press the Key.
Using the
FWD or the REV
Key, set the ‘Paper’ level to the
value determined in the previous
step. Press the
Key to set
the entry (indicated by the ‘*’)
and advance the menu.
Repeat for the ‘Gap’ (or ‘Mark’)
and ‘Empty’ levels.
!
QBQFS!TFOTPS!MFWFM!
Q+2:9!H+195!F+125!
! !
HBQ!TFOTPS!MFWFM!
Q+2:9!H+195!F+125!
! !
FNQUZ!TFOTPS!MFWFM!
Q+2:9!H+195!F+125!
!
!
!
!
Or, for reflective media:
!
QBQFS!TFOTPS!MFWFM!
Q+126!N+292!F+324!
!
!
NBSL!TFOTPS!MFWFM!
Q+126!N+292!F+324!
! !
FNQUZ!TFOTPS!MFWFM!
Q+126!N+292!F+324!
The selection will flash and the display heading will
change to indicate the item for entry.
17 After all entries have been made,
press the
Key to back out
of the menu and then press the
Key to save the settings
and return to the Ready Mode.
!
TBWF!DIBOHFT@!
FOUFS!LFZ!>!ZFT!
!
!
!
From ‘Ready’, press the FEED Key to advance to the
next label TOF.
Note: If the Advanced Entry Calibration fails, try the following procedure.
Re-enter Media Settings / Calibration / Advanced Entry / Sensor Gain and lower the selected Gain Setting number by one
(to make the sensor less sensitive). Select the new Gain Setting, save the changes, exit the menu, and then test your
media. Repeat the procedure until a usable media setting is obtained.