Rice Lake Datamax-ONeil M-Class - Manual (Page 29)

M-Class 21
4.5 Printer Setup Mode - Button Functions
In ‘Printer Setup’ mode, the buttons control the setting of the printer’s operational items such as media settings,
communications, and options as detailed below.
Notes: It is recommended that the Printer Setup Mode not be entered while in Peel Mode or with the optional Present Sensor
enabled. Depending on label size this can cause unpredictable results.
Printer and cutter faults are disabled during , but can still occur while printing “test” labels.
If at any time you wish to discard your changes and revert back to the previous values, simply turn off power to the
printer.
If you wish to restore Factory Defaults see Section 6.7.
To change Printer Setup:
Printer Setup Procedure
Printer Setup Mode
Prints the ‘Printer Setup Menu List’, see section 4.5.1
Prints the ‘Test Label’ for “test”
(Current Item and Value is printed)
Increments item’s value
Decrements item’s value
Accepts the current
values for “test”
PAUSE
PAUSE (Press and hold during power-up until the light turns off) STOP
PAUSE
Feeds one label for “test”
Press and
Release
( )
FEED
FEED
Press and
Hold
( ) (Enters Printer Setup)
CANCEL
Saves the current values
and resumes
Normal Mode
+
PAUSE
CANCEL
Press and
Release
Selects the next menu item
( )
Press and
Hold
”Direct Select” menu item
eg. 7 Error light flashes = Baud Rate menu item #7
( )
FEED
CANCEL
+
PAUSE
CANCEL
DONE