Rice Lake MSI-3460 Challenger 3 - Manual (Page 53)

Appendix 49
Display toggles
between “Error” and
“buttn” A key is stuck or is being held
down. Check switches for damage
Ensure that a remote is not
transmitting continuously.
RF remote does not
work. Units not mated See Setting the Transmitter
(Section 6.3) and Receiver
(Section 6.4) address
procedures.
Some RF remote keys
do not work but the
ACK light blinks. Keys were not enabled during
the setup process. Enable keys by running the
transmitter and receiver
address procedures.
Lo Batt is blinking Battery is low Recharge battery
Unit turns on, then
immediately off. Battery is low Recharge battery
Weight will not zero System not stable Wait for motion light to turn
off
Increase filtering for more
stability
Zero out of range LFT units have limited zero
range. Reduce the weight or
use tare instead
Weight will not tare or
total System is not stable Wait for motion light to turn
off, or if in a mechanically
noisy crane, increase the
filtering or reduce the size of
the scale increment ‘d.’ It is
also possible to increase the
motion window. Contact MSI
if you have a problem getting
the MSI-3460 to zero, tare,
or total due to stability issues.
Setpoint lights blink Setpoint is enabled and the
trigger point has been
reached. Disable setpoints if they are
not needed.
Manual total does not
work A function key is not set to
“Total” Set up Func1 or Func2 for
“Total”
Weight must be stable Increase filtering for more
stability
Problem Possible Cause Solution
Figure 8-1. Troubleshooting