Rice Lake Motorola DS457 Laser Scanner - Manual (Page 317)

CHAPTER 13 MISCELLANEOUS OPTIONS
Introduction
This chapter includes commonly used bar codes to customize how data is transmitted to the host device.
The imager ships with the settings shown in the
Miscellaneous Options Default Table on page 13-2
(also see
Appendix A, Standard Default Parameters
for all host device and miscellaneous imager defaults). If the default
values suit requirements, programming is not necessary.
There are two ways to change a parameter value:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
• For SSI and USB SNAPI hosts, send a “parameter send” command from the host system. Hexadecimal
parameter numbers are shown in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes. See the
Simple Serial Interface (SSI) Programmer’s
Guide
for detailed instructions for changing parameter values using this method.
To return all features to default values, scan the
Set Default Parameter on page 6-5
. Throughout the
programming bar code menus, default values are indicated with asterisks ( * ).
NOTE
Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where the bar code can be seen clearly, and
bars and/or spaces are not merging.
*
Disable No Read
(00h)
Feature/Option * Indicates Default
Hex Value