Rice Lake Motorola DS457 Laser Scanner - Manual (Page 149)

Serial Interface 9 - 3
Serial Host Parameters
Various serial hosts use their own parameter default settings (
Table 9-2
). Selecting standard, ICL, Fujitsu,
Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, or Omron sets the defaults listed
below.
Table 9-2 Terminal-Specific Serial Defaults
Parameter ICL Fujitsu
Wincor-
Nixdorf
Mode A
Wincor-
Nixdorf Mode B/
OPOS/JPOS
Olivetti Omron
Transmit Code ID Yes Yes Yes Yes Yes Yes
Data Transmission
Format
Data/Suffix Data/Suffix Data/Suffix Data/Suffix Prefix/Data/
Suffix
Data/Suffix
Suffix CR (1013) CR (1013) CR (1013) CR (1013) ETX (1002) CR (1013)
Baud Rate 9600 9600 9600 9600 9600 9600
Parity Even None Odd Odd Even None
Hardware
Handshaking
RTS/CTS
Option 3
None RTS/CTS
Option 3
RTS/CTS Option 3 None None
Software
Handshaking
None None None None Ack/Nak None
Serial Response
Time-out
9.9 Sec. 2 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec.
Stop Bit Select One One One One One One
ASCII Format 8-Bit 8-Bit 8-Bit 8-Bit 7-Bit 8-Bit
Beep On Disable Disable Disable Disable Disable Disable
RTS Line State High Low Low Low = No data to
send
Low High
Prefix None None None None STX (1003) None
*In Nixdorf Mode B, if CTS is low, scanning is disabled. When CTS is high, scanning is enabled.
**If Nixdorf Mode B is scanned without the imager connected to the proper host, it may appear
unable to scan. If this happens, scan a different serial host type within 5 seconds of cycling power
to the imager.