Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.0 - Manual (Page 78)

72 Counterpart User Manual
The 500-character limit of each print format string includes the output field length of the print formatting commands,
not the command length. For example, if the indicator is configured to show a decimal point, the command
generates an output field of 13 characters: the 10-character weight value (including decimal point), one space, and
a two-digit units identifier. The two header formats as limited to 100 characters each.
The default Counterpart print formats are shown in Table 7-2 and Table 7-3:
7.2 Customizing Print Formats
The following sections describe procedures for customizing the GFMT , NFMT and CFMT formats using the EDP
port, the front panel ( PFORMT menu), and the Revolution ® configuration utility.
7.2.1 Using the EDP Port
With a personal computer, terminal, you can use the EDP command set to customize the print format strings.
To view the current setting of a format string, type the name of the string ( GFMT.FMT or NFMT.FMT ) and press TARE
(Enter) . For example, to check the current configuration of the GFMT.FMT format, type GFMT.FMT and press ENTER .
The indicator responds by sending the current configuration for the gross format:
GFMT.FMT= GROSS
To change the format, use the GFMT.FMT or NFMT EDP command followed by an equals sign (=) and the modified
print format string. For example, to add the name and address of a company to the gross format, you could send
the following EDP command:
Indicator must be placed in the config mode with CONFIG shown on the display.
GFMT.FMT=FINE TRANSFER CO32400 WEST HIGHWAY ROADSMALLTOWN GROSS
A ticket printed using this format might look like the following:
FINE TRANSFER CO
32400 WEST HIGHWAY ROAD
SMALLTOWN
1345 lb GROSS
7.2.2 Using the Front Panel
If you have no access to equipment for communication through the EDP port or are working at a site where such
equipment cannot be used, you can use the
PFORMT menu (see Figure 7-1) to customize the print formats.
Format Default Format String Sample Output
H1 Company Name Street Address City, ST ZIP Company Name, Street Address, City, ST ZIP
H2 Company Name Street Address City, ST ZIP Company Name, Street Address, City, ST ZIP
Table 7-3. H1, H2 Formats
Note
Note