Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.0 - Manual (Page 16)

10 Counterpart User Manual
2.7.2 Digital I/O
The Digital I/O can be configured as either digital inputs or digital outputs as determined by the Digital I/O menu
(see Section 3.6.5 on page 35). The inputs are active (on) with low voltage (0 VDC) and can be driven by TTL or
5V logic without additional hardware. Use the Digital I/O menu (see Section 3.6.5 on page 35) to configure the
digital inputs. LEDs on the CPU board light when digital inputs are active (see Figure 2-4).
Digital outputs are typically used to control relays that drive other equipment. Outputs are designed to sink not
source, switching current. Each output is a CMOS circuit, capable of sinking 24 mA when active. Digital outputs
are wired to switch relays when the digital output is active (low, 0 VDC) with reference to 5 VDC supply. LEDs
on the CPU board light up when the digital outputs are active (see Figure 2-4).
Table 2-4. J3 Pin Assignments (Digital I/O)
2.7.3 Network Connection to Counterpart
Counterpart has an onboard Ethernet connection. It’s wireless connectivity is made possible with the optional
Lantronix WiPort wireless networking device (PN 108671). Refer to the WLAN installation instructions (PN
108680) included with the option card for installing and configuration instructions.
Figure 2-4. LED Light Locations
Note: The Ethernet LED light is on when connected at 100 mb/s and is off when connected at 10 mb/s.
2.8 Enclosure Reassembly
Once the cabling is complete, position the top plate over the enclosure and reinstall the four screws.
Connector Pin Signal
J3 1 +5V
2 Ground
3 DIG I/O 1
4 DIG I/0 2
5 DIG I/O 3
6 DIG I/O 4
LED LED
JP1 JP2 JP3 JP4 JP5 JP6
PC1
WD1 R
U
N P
G
M
PWR
+5 +3.3v
C3
ON SW
ISP RST
Port 3 LED
Port 1 & 2 LED lights
Port 3 LED
E t h e r n e t L E D
Light