Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.0 - Manual (Page 20)

14 Counterpart User Manual
2.13 Bracket Assembly Connecting Indicator to Scale Base
The Counterpart scale comes with an easy bracket assembly that conveniently hooks the indicator head to the
scale base. That assembly is found in the scale base box and is shown below.
Figure 2-9. Bracket Assembly Kit for the Counterpart Scale Base
Use the following steps to attach the indicator to the scale base.
Do not turn the scale upside down. Always work with the scale on its side. Damage to the load cell can
occur if the scale is turned upside down.
1. Stand scale base on its side to attach the bracket to the scale using the screws provided in the bracket kit.
2. Ensure that the cable underneath the scale base is threaded through the opening between the scale and the
bracket, otherwise it will not fit.
Figure 2-10. Attach Bracket Assembly to Scale Base While Scale is Tipped on its Side.
3. Set scale base down on a flat surface positioning the bracket assembly at the edge of a table.
4. Attach the indicator to the bracket using the second set of screws provided and screw white feet into
indicator base as shown below.
Figure 2-11. Shown - Indicator Attached to the Scale Base
Caution
Ensure the cable from
the underside of the scale is
run between bracket and
s c a l e p ri o r t o a t t a c h i n g
Note