Using weighvault – Rice Lake Counterpart Configurable Counting Indicator - User Manual - Version 2.0 User Manual

Page 64

Counterpart User Manual

5. Set the default gateway, DNS Pri, DNS Sec - no changes.

6. Set the local port - 10001.

7. Set the remote IP address - 192.168.0.02 (this is set same as computer above).

8. Set the remote port - 5466.

9. Set the Vault - set onboard.

10. Set up softkey - Code.

5.6.2

Using Weighvault

Once the above criteria have been met, IDs can then be entered into WeighVault and saved on the PC’s hard
drive. The Edit Product dialog box in Figure 5-3 shows ID parameters which can be saved in WeighVault.

For testing purposes, enter a few part numbers and click on

Save Changes to Database

Figure 5-3. WeighVault Edit Product Dialog Box

To access a saved ID from WeighVault over the network connection,

1. Using the

Counterpart

front panel, press the

CODE

key.

2. Enter an

ID CODE

value.

3. Press the

TARE(Enter)

key. The ID CODE is loaded and ready to use.

If the demo feature is complete and not being used permanently with WeighVault, go the your network
settings and turn off the Assign IP Address feature.

Note