Rice Lake Condec 3030 - Manual (Page 31)

12.5 Remote Commands and Error Codes
The following tables list all commands, and their descriptions, that
are accepted by the calibrator.
Table 5: Common Commands
Command Description
*CLS (Clear status.) Clears the error queue.
*IDN? Identification query. Returns the manufacturer, model num-
ber, and firmware revision level of the Calibrator.
*RST Resets the calibrator to the power up state.
Table 6: Calibrator Commands
Command Description
CPRT_COEFA Sets the custom RTD coefficient A
CPRT_COEFA? Returns the custom RTD coefficient A
CPRT_COEFB Sets the custom RTD coefficient B
CPRT_COEFB? Returns the custom RTD coefficient B
CPRT_COEFC Sets the custom RTD coefficient C
CPRT_COEFC? Returns the custom RTD coefficient C
CPRT_R0 Sets the custom RTD R0 resistance
CPRT_R0? Returns the custom RTD R0 resistance
DAMP Turns Damp on or off.
DAMP? Returns if DAMP is on/off
DISPLAY Turns on/off the displays specified in the command
DISPLAY? Returns which displays are on/off
FAULT? Returns the most recent error code
ERROR_LOOP Turns loop power on or off in percent error mode
ERROR_LOOP? Returns the current state of loop power in error mode
ERROR_MODE Turns percent error mode on or off
ERROR_MODE? Returns whether percent error mode is on or off
ERROR_PORT Set the pressure port for percent error mode
ERROR_PORT? Returns the pressure port for percent error mode
FUNC Sets the display mode as specified in the command
FUNC? Returns the current mode of the upper, middle, and lower
display
HI_ERR Sets the 100% of span limit for percent error mode
HI_ERR? Returns the 100% of span limit for percent error mode
LOCAL Returns user to manual operation of the calibrator
29