Rice Lake TP Series, Rice Lake Weighing Systems - Balance Manual - Manual (Page 25)

Functions Setup 21
Command Format
1. Composed of four characters (ASCII), including the terminators CR=0DH, LF=0AH.
2. Instruction for tare subtraction (zero adjustment)
3. Setup of output control
The output controls executed with commands [O0] - [O7] work the same as the output controls executed
through function setup on the main unit of the balance. The commands [08] and [09] are data request
commands issued to the balance.
Once any command from [O0] - [O9] is executed, the balance runs that function until another command is
entered. However, if the balance is switched off and on again, the output control is reset to the initial function.
3.4.5 Response Output
1. Response output format is composed of five characters, including the terminators (CR=0DH, LF=0AH).
2. Types of response outputs:
1 2 3 4
C1 C2 CR LF
C1 C2 Code Description Value Response
T (SP) 54H 20H Instruction for tare subtraction
(zero adjustment)
None A00: Normal end
E01: Tare subtraction cannot be executed due
to an error in the weight value
C1 C2 Code Description
O 0 4FH 30H Stop output.
O 1 4FH 31H Output continuous at all times.
O 2 4FH 32H Output continuous if stable (stop output if unstable).
O 3 4FH 33H Outputs once by pressing Memory (irrespective of whether stable)
O 4 4FH 34H Output continuous at all times.
O 5 4FH 35H Output continuous at all times.
O 6 4FH 36H Output continuous at all times.
O 7 4FH 37H Output continuous at all times.
O 8 4FH 38H Output continuous at all times.
O 9 4FH 39H Output continuous at all times.
1 2 3 4 5
A1 A2 A3 CR LF
A1 A2 A3 Code Description
A 0 0 41H 30H 30H Normal end
E 0 1 45H 30H 31H Command error
(Abnormal command received; other errors)
Note