Press. the display changes to judgment condition, Pressto select the desired condition, Press. the display changes to judgment range – Rice Lake TP Series, Rice Lake Weighing Systems - Balance Manual User Manual
Page 20: Press to select the desired choice, 4 setup of limit values by actual quantity loads, Press and hold down the set key, Press, 5 setting up limit values by inputting values, Press and hold down
5. Press
. The display changes to
Judgment Condition
.
6. Press
to select the desired condition.
7. Press
. The display changes to
Judgment Range
.
8. Press
to select the desired choice.
9. Press the
Set
key. The balance terminates the function setup and returns to measurement mode.
3.3.4
Setup of Limit Values by Actual Quantity Loads
1. Press and hold down the
Set
key.
2. Release the key when [
] is displayed. The currently set lower-limit flashes.
3. Load the sample of the lower-limit value on the measurement pan.
4. Press
. After the lower-limit value has been saved, the balance displays it briefly and proceeds to the
following setup.
If One-Point setup was chosen, the setup is complete.
5. The display changes to [
], indicating that the upper-limit value can be set. The currently set upper-limit value
flashes.
6. Load the sample of the upper-limit value on the measurement pan.
7. Press
.
8. After saving the upper-limit value, the balance displays it briefly and terminates the setup.
3.3.5
Setting up Limit Values by Inputting Values
1. Press and hold down
.
2. Release the key when [
] is displayed. The currently set lower-limit value flashes.
3. Press
. All the digits are displayed, the flashing digit on the right can be changed.
4. Press
repeatedly until the desired value of the flashing digit is entered.
5. Press
. The flashing digit moves one position to the left with each press of
. When the left most
digit is selected, the flashing digit will advance to the rightmost digit position after a press of
.
6. Enter the lower-limit value by selecting a value with
and moving the digits with
as needed.
7. The display changes to [
], indicating that the upper-limit value can be set. If there is an upper-limit value
already set, that value will flash.
8. Press
. Return to step 2 and follow the same procedure as described for the lower-limit value to enter the
upper-limit value.
9. Press
. After saving the upper-limit value, the balance displays it briefly and terminates setup.
Note