Rice Lake Combination System - Precision Loads PL9710 Indicator - Manual (Page 7)

PL9710 Installation Manual - Overview 3
1.3 Menus
The
PL9710
has different menus used for setup and calibration of the indicator.
1.3.1 Function Menu
The Function menu is used to:
• Reset the empty weight
• Select a gross or net weight mode
• Select the preferred speed for the auto-cycle mode
1.3.2 Setup Menu
The Setup menu is used to:
• Calibrate channel 1 or 2
• Enable the advanced calibration feature
• Select the proper weight unit, such as pounds or kilograms
• Select the different weight increments, commonly called the grad size
• Set the time in hours and minutes
• Set the date
1.3.3 Advanced Setup Menu
The Advanced Setup menu is used to:
• Enable the filter
• Select the number of load cells per channel
• Enable the load and delivery feature
• Enable the lift to weigh feature
• Enable the sensor output feature
• Enable the cal
• Enable the accumulator feature
• Select the transmitter models
• Select the channel mode
1.3.4 Setup ID Menu
The Setup ID menu is used to:
• Establish ID numbers for the load and delivery feature
1.3.5 Setup Serial Port Menu
The Setup Serial Port menu is used to:
• Select the serial port baud rates
• Set the serial ports to continuous output
The following chapters guide you through the setup and calibration of the indicator.