Rice Lake Combination System - Precision Loads PL9710 Indicator - Manual (Page 27)

PL9710 Installation Manual - Advanced Setup 23
12.5 Enabling Sensor Output
This feature is available only with two-channel systems
that use two load cells per channel.
1. Press the
Menu
key for about 12 seconds until the
information display shows Advanced Setup
Menu.
2. After releasing the
Menu
key, the information
display will show Setup selection and the weight
display will show Setup.
3. To select the Sensor Output submenu, press the
Up
key until the information display shows
Enable Sensor Output: YES.
4. Press the appropriate softkey for
Yes
or
No
.
5. Press the
Cancel
softkey to return to the submenu
selection.
6. Press the
Cancel
softkey again to exit Advanced
Setup and return to normal operation.
12.6 Enabling Cal
This feature is available only with two-channel systems
and with load cells that have the same output.
1. Press the
Menu
key for about 12 seconds until the
information display shows Advanced Setup
Menu.
2. After releasing the
Menu
key, the information
display will show Setup selection and the weight
display will show Setup.
3. To select the CAL submenu, press the
Up
key
until the information display shows Enable Cal
NET TOTAL: YES.
4. Press the appropriate softkey for
Yes
or
No
.
5. Press the
Cancel
softkey to return to the submenu
selection.
6. Press the
Cancel
softkey again to exit Advanced
Setup and return to normal operation.
12.7 Enabling the Accumulator
1. Press the
Menu
key for about 12 seconds until the
information display shows Advanced Setup
Menu.
2. After releasing the
Menu
key, the information
display will show Setup selection and the weight
display will show Setup.
3. To select the Accumulator submenu, press the
Up
key until the information display shows Enable
Accumulator: YES.
4. Press the appropriate softkey for
Yes
or
No
.
5. Press the
Cancel
softkey to return to the submenu
selection.
6. Press the
Cancel
key again to exit Advanced Setup
and return to normal operation.
12.8 Selecting the Channel Mode
1. Press the
Menu
key for about 12 seconds until the
information display shows Advanced Setup
Menu.
After releasing the
Menu
key, the information
display will show Setup selection and the weight
display will show Setup.
2. To select the Channel Mode submenu, press the
Up
key until the information display shows
Channel mode: 2 Channels.
3. Press the appropriate softkey.
4. Press the
Cancel
softkey to return to the submenu
selection.
5. Press the
Cancel
softkey again to exit Advanced
setup and return to normal operation.
The display will show Transmitter Ch-2= 9100.
6. When finished, press the
Cancel
softkey to exit
the Advanced Setup menu.
The information display will show Setup
selection.